Saltar al contenido principal

Segunda generación de iPhone. Modelo A1241 / 8 o 16 GB de capacidad / plástico negro o blanco de nuevo. La reparación es más sencilla que el primer iPhone. Requiere destornilladores, curvas y herramientas de succión.

Preguntas 1158 Ver todo

Digitizer not completely functional after replacement, faulty port?

I replaced the digitizer on a iPhone 3g. The 1st connector doesnt sit properly. I looked at pictures of a 3gs vs. 3g connector so I am sure mine is for a 3g. attempted to use tape to hold it down but some dead spots still are present. would cleaning the ports help? any solutions will help.

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación -1
Agregar un comentario

1 Respuesta

Solución Elegida

check for bent pins/dirt not allowing connection. connector 1 can be tricky, shouldn't require undue pressure but you should be able to look from the side and see whether you are lined up right as you are attaching.

Fue útil esta respuesta?

Puntuación 1

1 comentario:

3g and 3gs are very similar to look at but connectors are different lengths. measure the one on the motherboard and compare to that on the lcd...then you'll know if you just aren't lining them up right or you've ordered/given the wrong part.

- de

Agregar un comentario

Añadir tu respuesta

jake estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 3,120