Saltar al contenido principal

Información y guías de reparación para el iPhone 6 que salió a la venta el 19 de septiembre de 2014. Números de modelo: A1549, A1586 y A1589

Preguntas 4994 Ver todo

How to troubleshoot my battery

I have a water damaged iphone 6 and I'm trying to isolate where the problem is.

I've removed the motherboard, cleaned it and all connectors with denatured alcohol, reassembled and ... nothing.

When I plug the phone into a charger with a USB meter in line, the charger is putting out 5.15V but 0 amps, so I know the phone is not taking a charge.

I've tried checking the battery itself with my multimeter, testing at the red and green locations.

Block Image

No power.

When I tested the red and blue locations I got a brief .27 V reading and drained to 0 in a second or 2. Not sure what that's about. A capacitor charging and draining?

I also plugged the phone into the charger and read where the red and green leads connect on the motherboard.

No power.

This makes me think that, while the battery appears to be dead, the problem is possibly in the charging circuitry as well. Is this a reasonable guess?

Any ideas as to where to go next?

Thanks in advance,

Tom

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 2
Agregar un comentario

1 Respuesta

From what you’re describing it sounds like your battery has next to no charge in it. For whatever reason when batteries drop below a certain voltage they lose the ability to be charged through the logic board. If this is the case the fix is simple: take the battery out of the phone and plug it into a battery activation test charge fixture, if the battery is quite dead it should draw about 1.8A through the fixture. Allow the battery to charge until it only pulls around 1.0A - 1.2A and then reinstall it back in the phone and plug in the phone. At this point the logic board should detect the battery and begin to charge it.

Since you mentioned water damage it is also possible that there is a short somewhere preventing charging. I would start by checking VCC_MAIN for shorts and going from there

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Tom Daniels estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 272