Saltar al contenido principal

The Black and Decker LI2000 was released February 2011.

Preguntas 5 Ver todo

What is the selector for at the tip of the screwdriver?

I'm not sure what the selector at the top of the driver is for, there is a symbol with a hand and another with a power symbol. I'm not sure what these are meant for

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Calificación 0
Agregar un comentario

Skip the upgrade.

Descuento de $10 en tu factura de $50 con
SKIPANDSAVE10

Save Now

Skip the upgrade.

Take $10 off $50 with
SKIPANDSAVE10

Save Now

1 Respuesta

Solución Elegida

It is the indicator for the screwdriver to be in either auto mode where the motor in the drill activates to spin the hex bit, or in manual mode is when you use the screwdriver as if it were a traditional handheld screwdriver(without the motor, spinning with your hand.) manual mode could be used if the screwdriver is running low on battery life and you don't have a screwdriver on hand. Take a look at the troubleshooting page for the LI2000.

Fue útil esta respuesta?

Calificación 0
Agregar un comentario

Añadir tu respuesta

eric nance estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 53