Saltar al contenido principal

Procesador Intel de doble núcleo modelo A1502 / 2.4, 2.6 o 2.8 GHz / Lanzado en octubre de 2013

Preguntas 552 Ver todo
Pregunta Cerrada

Screen Backlight behaving strangely after minor soda spill?

I spilled soda on my macbook pro 13" late 2013. The screen backlight started to acts nuts, It decides to turn on and off by itself. Most often, however, it is not working- But when it turns on, it stays on until I close the lid or restart the device. I have no Idea how to fix it myself. Also, in my country no one is using or fixing Macs, so can't get some one to fix it.

What do you think the issue is knowing that its been 5 months and no improvement.

P.S. Apple says you need everything new inside the macbook pro(That when I was abroad ). The repair price is close to a brand new one. I have been using it connected to a monitor for the the time the screen backlight is off and when it gets resurrected I use it as normal laptop with a shiny retina screen.

Block Image

Block Image

Block Image

Block Image

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
2 comentarios

I just received a new logic board from iFixit, and I installed it on the the macbook. Everything works fine now, thank you iFixit.

- de

AWESOME! Good job.

- de

Agregar un comentario

4 Respuestas

Respuesta Más Útil

Hi there, Sounds like the backlight has been damaged. It is located under the keyboard and can be replaced with out having to remove the keyboard. It is quite a technical repair though requiring you to remove the motherboard. The part is not to expensive to buy, just requires a bit of computer dismantling knowledge.

Good Luck

Fue útil esta respuesta?

Puntuación 1

1 comentario:

My issue is the screen backlight not the keyboard. If you got it right, what exactly does it look like in order to change it and get the screen lights to work.

- de

Agregar un comentario

Have you tried disassembling it, drying it out, and cleaning up the dried soda/syrup? I'm thinking the culprit might be an intermittent short occurring.

Fue útil esta respuesta?

Puntuación 0

1 comentario:

Yes, I have cleaned and dryed the liquid.

- de

Agregar un comentario

Post some pics of the board and by the lcd connector too.

Fue útil esta respuesta?

Puntuación 0

2 comentarios:

Will be posting picture shortly

- de

Posted above

- de

Agregar un comentario

Block Image

I think there's corrosion on the lcd board you will need to remove the clutch cover to expose it.

Fue útil esta respuesta?

Puntuación 0

2 comentarios:

I did that already and its clear.

- de

Just replace the lcd flex cable then

- de

Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 139