Help! I was replacing my LCD screen and when I first put the screen on with the ribbon cables I noticed there was a white line so I detached them and reattached them and now the screen doesnt work. Then I went to reattach my old screen and it doesnt work either. My phone is vibrating and is fine but now my screens arent working. Did I just do something to the circuits?
Es esta una buena pregunta?
Rep: 30.6mil
25
71
41
Yikes!
Did this happen after you screwed down the LCD shield? Hope not---because that is a difficult problem. Mixing up the screws on the iPhone 6 shield causes a no backlight problem when the long screw is screwed into the wrong bracket and tears the traces in the board. Repairable, but really tough.
But first, rule out the easy stuff. 1--hard reset--lift off the battery connector and reseat and power on.
2--it could be just a blown backlight filter--especially if you're sure you did not mix up the screws. That is still a board repair, but much more straightforward.
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 453
