Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

La Canon EOS 7D fue la primera cámara profesional de gama alta de Canon con un sensor de recorte APS-C.

Preguntas 47 Ver todo

My flash won't pop up on my EOS 7d

My flash won't pop up on my EOS 7d, any suggestions on how to fix this?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1

Comentarios:

I have the opposite problem - the pop up won't close - since it was new but hate to part with it to have it looked at

- de

Agregar un comentario

El kit de herramientas esencial

Las herramientas más útiles en nuestro kit más compacto.

Compra ahora

El kit de herramientas esencial

Las herramientas más útiles en nuestro kit más compacto.

Compra ahora

4 Respuestas

Respuesta Más Útil

In the flash shoe on the top of the camera, there is a metal spring plate. Under the plate you will find a white cylandars that goes through the hot shoe (about as thick as a paper clip). When an external flash is pushed onto the shoe, this pin is pushed down and tells the camera there is an external flash in the flash shoe. This disconnects the internal flash. Spillage can cause this pin to stick down. Remove the battery, and then put a little Windex on a clean toothbrush and clean the pinhole. Blow lightly to evaporate. The pin should pop up, but it might take a couple of cleaning attempts.

Another cause could be that sticky liquid spillage has gotten on the pivots for the flash. Once again, cleaned with small amount of Windex on a q-tip may free the pivot. One of the pivots is a screw. Sometimes it is rusted, and needs to have the rust scraped off and then a light coating of grease applied.

Fue útil esta respuesta?

Puntuación 3

Comentarios:

Thanks for this advice. It was exactly what I needed! You rock

- de

Good advice, worked the first time.

- de

Hi I have the same problem. Do you have to remove part of the hotshoe to clean the cylinders?

- de

Agregar un comentario

Excellent solution! 10 sec and it solved!

Thank you!

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

In almost all the canon EOS camera I’ve seen this problem . In almost all cases it is caused by bad care of the camera. A large amount of faults are caused by dirty cameras. Grease from fingers, small amounts os dust and dead skin building up until it failed. The solution above is correct. But care is the problem linked with cleanliness. Not only the specific area and fix above but also the seating area must be clean. This is to often ignored. As is each area on a camera where to surfaces meet such as the lense

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Hi i own a 7d the problem is very likeiy to be in the little pin under the spring on the hot shoe on the right hand side

i have used isopropyl alcohol and a tooth brush when it has worked i then use a little crc or wd 40 on the end of a tooth pick to keep the pin from getting stuck again

i hope this helps

Update (03/08/2019)

Hi again

if you are living in new zealand i can give you an address to send your cameras to for repairs its CW Services ltd

62 church street

timaru

7910

new zealand —-or www.camerarepairs.co.nz

Greg is one of the best techs in nz for canon repairs

I have used him a few times and his costs are very fair

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Andy estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 6

Ultimos 7 días: 21

Ultimos 30 días: 106

Todo El Tiempo: 8,279