Saltar al contenido principal

Pantalla iPad Mini de 7.9 pulgadas, con 16, 32 o 64 GB de almacenamiento.

Preguntas 630 Ver todo
Pregunta Cerrada

potential problems by soldering the ic chip incorrectly?

Hi

is there any potential pronlems if I solder my own ic chip to a new digitiser? Would it blow anything if a couple of contacts were touching? Or would it simply not work?

Would like to practice this, but not at the expense of someones ipad when i repair it.

would be handy to do, as im fed up of these cheap ones which flicker everytime I lay it flat, and have to cover it in tape.

Thanks

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

1 Respuesta

Respuesta Más Útil

Most likely worst case scenario: dead device.

Update

If you don't do it right, you could get the power leads or voltage to where they don't belong. Hence possibility of a dead device is strong.

Fue útil esta respuesta?

Puntuación 2

3 comentarios:

Is that fact or just a guess? Just that I would think as the connections would only ne sending signals, then I would imagine the digitiser would go a bit loopy as if the flex cable was pinched? But that's just a guess. Wonder if anyone has actually done it wrong? I know all the local repair shops in this area don't solder the parts.

- de

If you don't do it right, you could get the power leads or voltage to where they don't belong. Hence possibility of a dead device is strong.

- de

Ok, I'm not really experienced at soldering, but practice makes perfect.

wonder if there's some sort of schematic for that connection?

- de

Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 106