Saltar al contenido principal

Third generation of the BMW 3 Series / Also known as the E36

Preguntas 16 Ver todo

How to change the compressor on 99 bmw

hoh to change the compreser on 99 bmw

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
1 comentario

What model is your BMW?

- de

Agregar un comentario

2 Respuestas

Solución Elegida

bert mackey, try this:"

A/C Compressor, replacing

1 . Following manufacturer's instructions, connect an approved refrigerant recovery/recycling/recharging unit to A/C system and discharge system .

WARNING

Do not discharge/charge the A/C system without proper equipment and training. Damage to the vehicle and personal injury may result.

2. Remove splash shield from under engine.

3. Mark A/C drive belt with direction of rotation . Remove A/C belt tensioner trim cap. See Fig. 34.

Block Image

4. On 4-cylinder engines: Loosen A/C belt tensioner bolt under trim cap, then remove belt from A/C compressor.

Block Image

Fig. 35 . 4-cylinder engines: Loosen retaining bolt A on tensioner to release drive-belt tension. To increase tension, rotate pulley in direction of arrow, then tighten bolt A.

5. On 6-cylinder engines: Release tension on A/C belt by turning tensioner pulley clockwíse (against spring tension).See Fig. 36.

Block Image

6. Disconnect electrical harness connector from compressor.

7. Remove A/C pressure hose and suction hose flange bolts from compressor. Plug hoses immediately See Fig . 37.

Block Image

8 . Remove compressor mounting bolts . See Fig . 38. Re-move compressor by pulling downward from underneath car.

Block Image

9. Installation is reverse of removal.

CAUTION-

" Always replace O-rings when reconnecting refrigerant fines.

" When installing a new compressor always replace receiver/drier unit.

10. Before recharging, evacuate system for at least 30 min.Recharge system following equipment manufacturer'. Hope this helps, good luck.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Make sure you go to a certified A/C technician and have them recover the supply(R-34 or R12) in the system before you change it or you risk getting it sprayed on your hands or eyes. After that, simply look at the bolts that hold it onto the hold where it is on. Should be 4 bolts.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

bert mackey estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 5

Ultimos 30 días: 22

Todo El Tiempo: 2,310