Saltar al contenido principal

Quinta generacion de iPhone. La reparación de este dispositivo es fácil y requiere destornilladores, herramientas de hacer palanca, y paciencia. GSM/CDMA /16, 32, o 64 GB / Negro o Blanco.

Preguntas 3019 Ver todo

Bottom screws won't come out, just spin in place.

After replacing the battery and back cover on my iPhone 4S, I replaced the pentalobe screws on the bottom of the phone with phillips screws from the iFixit liberation kit.

I'm having two problems:

1) The screws are not flush with the bottom edge of the phone and won't go in any farther. They are almost all the way in, but not quite.

2) The screws won't come out. I can turn them clockwise or counterclockwise, but they don't go in or out. They just spin in place.

Neither of these is a big problem right now, though I'd prefer that the screws go all the way in and sit flush. My concern is that I can't open up the phone if I need to make another repair in the future.

Any idea what is going on here? Is there anything I can do about it?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 11
Agregar un comentario

4 Respuestas

Respuesta Más Útil

Sounds like the screws are stripped. You may want to try some of these tricks to remove them: What are your tips/tricks for removing or extracting stripped screws?

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

If they are just spinning just try sliding the back cover up

Fue útil esta respuesta?

Puntuación 2

Comentarios:

this actually fixed the problem thank you.

- de

Agregar un comentario

I need help with that my creen went all black it son but just the screen and it makes noices when i plug in the charger and idk what to do, were do you think i should put it???

Fue útil esta respuesta?

Puntuación 2

Comentarios:

and it just wont work:(

- de

What do you mean?

- de

Agregar un comentario

With cheaper (vendor-supplied) drivers, the shaft sometimes loosens. It looks and feels like the screw is turning, because the handle is turning. In fact, it is only the handle that is turning; the shaft (and the screw) remain stationary. Strange, but it happens. Solution: try another screw-driver.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

sbroberts estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 22

Ultimos 30 días: 133

Todo El Tiempo: 34,694