Saltar al contenido principal

Repair and disassembly guides for Uniden phones.

Preguntas 258 Ver todo

reapplying a broken piece from ther circuit board

Uniden Model: TCX800 handset - a capsule shaped piece (12.2M-4KU) broke off the circuit board. It looks as though it was glued on. If so, what type of glue do I use? It is obvious that I am not a student, just a mom with a broken phone.

Update

I did not see where I could edit on my original post so I've added the images here:

Block Image

Block Image

Block Image

Block Image

Block Image

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación -1

1 comentario:

Kelly Creech, any chance you could post a couple of images of the component as well as the logic board so we can see what you see/ Parts like this are usually not glued but surface soldered. To add images to your question, follow this guide Agregar imágenes a una pregunta existente

- de

Agregar un comentario

2 Respuestas

Kelly Creech, that component looks like a Crystal/ Oscillator which would correspond with the "X" as reference designator. Most likely a 12.2mHz and I am sure we could locate that if needed. Right now, you can strictly solder it back. All you need is a small soldering iron some flux and solder and a bit of practice. For some decent tutorials, check here and hereas well. Hope this helps, good luck.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Hi Kelly,

You can totally solder that back on mama! Just make sure you don't "just try and superglue it and see what happens" --that won't work and it will mess things up for when you have to do your solder work.

jessa

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Kelly Creech estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 920