Rep: 1
1
Has anyone experienced any loss of signal after replacing the LCD assembly? I just swapped mine out and now my phone will not go any higher than 3 signal bars..
I have done reboots & reset all network connections.
Just curious if there are any contacts I may have touched to caused this? Similar to iphone4's wifi & 3g.
Es esta una buena pregunta?
Rep: 73.8mil
19
111
82
Make sure you didn't touch the lower half of the logic board
Fue útil esta respuesta?
I'm pretty certain I did not touch anything.. I was unable to put the metal plate that goes over the LCD connectors. I could not for the life of me get it screwed in without the lower cable popping out.
Hope that is not the cause..
Hook up the bracket from the left side.
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 144
