Logic board solder pad repair?
Hi,
HELP HELP HELP!
In an attempt to replace a fpc connector I have managed to damage solder pad (contact) on the logic board of an ipad 2.
What's the best way to go about repairing surface mount inorder to put in the new fpc connector.
Any advise would be much appreciated!
Thank you
Nikki
Es esta una buena pregunta?
2 comentarios
Post a picture Nikki, we can help you figure out where to run a fine wire jumper to bring flow back to this pin.
- de jessabethany
Done.
As you can see it is quiet bad :(
- de Nikki