Saltar al contenido principal

Modelo núm. A1367 / Capacidad de 8, 16, 32 o 64 GB

Preguntas 913 Ver todo

Missing battery soldering pad?

I was soldering in a new battery on my 4th gen ipod touch when i realized the middle battery terminal was missing from the board. I orderered a carbon based "non conductive wire glue", if i just apply this where the pad was and stick it to the battery, will it work? or do i need to use a silver epoxy/ink? also, i have a scrap board i can play with that has all three battery terminals, can i somehow rip one off and put it on the other board? thanks a lot

Block Image

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
Agregar un comentario

2 Respuestas

The thing that is important isn't the solder pad, but the connection between the solder pad and the underlying copper trace that leads to it. If the pad is severed, the connection to the trace has been severed.

You can repair this by gently removing some of the green mask near the pad to expose the copper, then solder a thin copper wire to the trace (thin, like a single strand of copper braid) then coil that wire and add a bead of solder to essentially create a new pad.

Jessa

Fue útil esta respuesta?

Puntuación 0

2 comentarios:

thanks for your response, i will give this a try and get back to you, Thank again!

- de

@kelten66 have you succeeded?

- de

Agregar un comentario

This works good with some old solder wick. I cut it down very thin. It had enough solder to stick to the connection points I scraped off. A microscope is very handy as well as a new xacto blade.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Kelten estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 642