Saltar al contenido principal

Cuarta generación de iPad, lanzada el 2 de noviembre de 2012, disponible en modelos de 16, 32 o 64 GB. Número de modelo A1458

Preguntas 218 Ver todo

I mistook the home button ribbon cable connector

I have broken off the square 5 wire connector next to the home button ribbon cable, and all the soldered leads are no longer attached. How to repair?

I have attached two pictures from the guide. I mistook the connector as the picture was a little too small to see, only after "prying up the flap" did I discover I pried up the soldered connector.

Is this repairable or have I junked my new iPad 4th ten pride and joy?

Here are pictures where the connector is shown as right next to the cable connector…

Block Image

Block Image

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
Agregar un comentario

1 Respuesta

The connector can be replaced but the leads may need to be re-routed. It is a difficult repair, you could ruin it further if not done carefully

Fue útil esta respuesta?

Puntuación 0

1 comentario:

I just found a repair service who will solder a new connector to my logic board for $50 plus shipping. Will advise once I have it back in house.

- de

Agregar un comentario

Añadir tu respuesta

Al Taylor estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 14

Todo El Tiempo: 440