Saltar al contenido principal

Pantalla iPad Mini de 7.9 pulgadas, con 16, 32 o 64 GB de almacenamiento.

Preguntas 630 Ver todo

iPad Mini Home Button not working after digitizer replace

I replaced the digitizer on an iPad Mini and now the home button doesn't work. Not to be mistaken for the issue where the home button thinks it is always pressed. It is not responding at all. Anyone??

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 3
Agregar un comentario

4 Respuestas

Respuesta Más Útil

Have a look at this thread: iPad Mini Home Button Not Working After Digitizer Replacement

the answer was given by GtechRepair: "The easiest solution Is to go back to the old screen at the bottom where the Home button is located, There you will see two pieces of fabric tape, The one closest to the home button will be layered over a clear piece of tape, try to remove them together, use x acto knife to lift up corner, then a good pair of tweezers to peel it off.

Perform the same procedure To the fabric tape to the left, Then place both pieces down on your new digitizer, In the same place that they were in on the original. This should solve your problem 100%."

Block Image

these black tapes go here:

Block Image

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

Same here :(

Fue útil esta respuesta?

Puntuación 0

1 comentario:

Im going to try a new digitizer assembly when I can. Have you tried this?

- de

Agregar un comentario

Same issue

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

NICE.. SWEET! (If only I hadn't thrown that old broken digitizer away :(

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Gavin estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 3,550