Rep: 255
5
4
I want to clean off all possible corrosion in my Logicboard from water damage. Since I will be removing the board there will be no power therefore I should be able to just dunk it right in isopropyl and clean it without a worry of something being wrecked, correct?
I just want to confirm that all is fine.
Thanks,
Josh
Es esta una buena pregunta?
Rep: 6.1mil
15
20
5
yes you can. but an ultra sonic clean would be better...
Fue útil esta respuesta?
Rep: 67
3
hi i fix mainly iphones, if it recent i dry it using hot air gun only short amount of time then if the corrosion is really bad the chips on the board are so small they corrode away fast. so i generally just use wd-40 and a little brush to remove any corrosion and that works getting the phone back to life but if it is bad normally something like camera or or touchscreen connectors are gone which i have no idea how you would go about getting that sorted. good luck
chris
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 691
