Saltar al contenido principal

Segunda generación de iPhone. Modelo A1241 / 8 o 16 GB de capacidad / plástico negro o blanco de nuevo. La reparación es más sencilla que el primer iPhone. Requiere destornilladores, curvas y herramientas de succión.

Preguntas 1158 Ver todo

Home Button not the same after successful battery install...

After installing a battery in my iPhone 3G, my home button takes a bit more pressure to work? Everything works fine- I went and purchased a can of compressed air and re dissembled the cover and tried to clean out the backside of where the button is, but it’s still not as easy to press before I dissembled the first time. I did notice there are contacts where the button on the backside contacts the logic board (I think it’s the logic board)… My question is, should I try cleaning the “points” with a Q tip and distilled water? Any other ideas? Thanks in advance.

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación -1
Agregar un comentario

1 Respuesta

Solución Elegida

You could certainly try that- it could also be that the front is just not quite clicked into place the whole way.

Fue útil esta respuesta?

Puntuación 2

1 comentario:

Solved!!! That was it, I pressed a bit harder right around the home button and it clicked just a tiny bit- good to go... Thanks for the reply!!!

- de

Agregar un comentario

Añadir tu respuesta

diggity estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 2,340