iPhone 4 power Logic Board problem?

Question

iPhone 4

iPhone de cuarta generación. La reparación es sencilla, pero el cristal frontal y la pantalla LCD deben ser reemplazados como una unidad. GSM / 8, 16, o 32 GB de capacidad / Modelo A1332 / Blanco y Negro.

Preguntas 2375 Ver todo

Gauthier @gauthier32416

Rep: 45

2

3

Publicado: 23 de dic. de 2012

Opciones

iPhone 4 power Logic Board problem?

I got here an iPhone 4 which only boot with a pre-charged battery.

If the battery runs down, I can charge it, but the charge icon don’t go away and it’s impossible to boot.

I replaced the dockconnector an battery twice, but without result. There are also no marks of waterdamage, the device looks fine inside, except 1 thing is damaged (http://img834.imageshack.us/img834/1862/...)

Could this be the cause of the problem? Someone who has got the same problem?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación -1

3 comentarios

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..?

23 de dic. de 2012 - de Jordy

Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part.

23 de dic. de 2012 - de Gauthier

Bridging also doesn't work..

24 de dic. de 2012 - de Gauthier

Agregar un comentario

2 Respuestas

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..? — Jordy
Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part. — Gauthier

oldturkey03 @oldturkey03 Rep: 782.2mil 1.1mil 893 2.3mil · Answer 1 · 2012-12-24T09:32:09-07:00

Respuesta Más Útil

oldturkey03 @oldturkey03

Rep: 782.2mil

1.1mil

893

2.3mil

Publicado: 24 de dic. de 2012

Opciones

Gauthier Top, the part that you showed on the image is a SMD capacitor 27PF 5% NP0-C0G. I do have to say that bridging components is not always a wise choice, if bridging would always work, the components would not be necessary, and the manufacturers could/ would eliminate those. So, you can try and replace it, if you know how to work with very small components and have the right tools. Otherwise you cold get it repaired by a local electronics shop. Hope this helps, good luck.

Fue útil esta respuesta?

Sí No

Puntuación 1

Agregar un comentario