Saltar al contenido principal

Modelo A1136 / disco duro de 30, 60 u 80 GB / frente de plástico negro o blanco

Preguntas 797 Ver todo
Pregunta Cerrada

Broken headphone jack, tried to replace, but...

Ive got a new hold switch/headphone jack for my iPod. However when I went to install it I realised I have lost/broken off the little brown clip that holds the connector in place on the logic board (http://s1.guide-images.ifixit.com/igi/6G...). There is no way it will hold without the clip. Is there anything I can do, or am I able to purchase another clip?

Thanks

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Solución Elegida

Unfortunately, I'm aware of anywhere that sells just the clip.

Some have had nominal success with electrical tape holding down the cable, but this is temporary and not very likely to work.

Your best bet is most likely to purchase a dead logic board off of eBay and carefully scavenge the clip.

Good luck!

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

that happen to me with an iphone and I just had to use an electric style putty/rubber cement to fix it. I tried the electric putty on one item and haven't had a problem. However I quickly relies that with the putty it would make it difficult to re-repair if needed so i went with the rubber cement and it works great on my iPod for this purpose.

Hope this helps Ciao,

Maverick6017

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 1,941