Repara tus cosas Comunidad Tienda

iPhone de cuarta generación. La reparación es sencilla, pero el cristal frontal y la pantalla LCD deben ser reemplazados como una unidad. GSM / 8, 16, o 32 GB de capacidad / Modelo A1332 / Blanco y Negro.

Preguntas 2375 Ver todo

Opciones

How to apply a jumper to the blue inductor?

hello DEAREST @johnkustic PLEASE HELP me

how can i jumper it ? please ?

recieved iphone 4 after water damage with erro -1 in itunes

now its fixed

but constently losing wifi/gsm signal

the phone has imei and all ,please help me if you can

?

with what wire can i use to jumper it,its too close to another fuse ,

you saID YOU made a jumper with soldering iron ,since its too small i guess you only implemented soldering iron and thats it ?

can it also be the bb or other coil?

can you please answer me ?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación -1
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Respuesta Más Útil

Opciones

Hey 7Gnosis Sorry for late reply did not see your post. Just use regular soldering iron, soldering wire and no clean flux. Just apply little bit of flux and after melt soldering wire to connect the two points where blue coil is missing.

Hope that helps.

Fue útil esta respuesta?

Sí No
Puntuación 3

2 comentarios:

@Johnkustic

Hi, a have a same issue. crap blue coil is missing i have solder a Jumper today but no luck. still no Service /Searching may be is wrong soldering. Do U have any pix with the Jumper on this Place . I tried with conductivity silver before there was the same will try again tomorrow

thank you Etienne

- de

Thanks John, works like a champ! A customer of mine damaged her phone with a home repair. I did not need to run a wire as posted by some others. Simply cut a piece of small solder and laid it where the blue coil once was and voila.

- de

Agregar un comentario

Opciones

The answer to your questions, how to fix the blue inductor coil causing a signal problem, the solution is easy we have repaired many with a 100% success rate. If you look at the signal antenna which you plug the cable into, simply run a wire from the left side bridge it to the right side point on the blue coil and follow it all the way to the furthest (right) component on the top left side. This will act as a 'bypass route' and your signal will start to work again.

All it takes is a bit of micro-soldering knowledge and some 0.1mm wire and basing soldering equipment. This will fix your problem guaranteed, providing it was the missing blue coil that caused your signal issue in the first place.

Kind regards,

Ideal mobiles

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Añadir tu respuesta

7Gnosis estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 2,157