Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Ayuda

Aporte original por: Alan ,

Texto:

HELLO PPL,

when i changed screen i cut through the vol button ribbon but i cut it after the vol buttons and before the power switch (so volumes were working power button was not)

power down ipad via removing the logic board of the battery DONT PULL THE BLACK SILVER BLOCK ABOVE BATTERY with the single screw in (you pull the logic board up off the battery connecters)

you will need to remove the 2 screws in the corners of the end of the logic board in plain sight not were the digitalizer plugs.

now put a plastic pry tool the lift the logic board there is a bit of tape underneath.

with the logicboard in the air one end you will see how the board connects to the battery.

simply hold off battery for  few mins (press some buttons only to drain the bit of power on the board then simply put back together and re try the screen.)

if not working try and plug usb in to ipad as this will power it up then you will know if the button ribbon is damaged.

Estatus:

open