Saltar al contenido principal
Ayuda

Aporte original por: Josh Crowe ,

Texto:

I know this is old, but I lifted the power pad on the right... the case was already open when the pod started getting really hot on the back. I grabbed the battery ribbon cable in hopes that the thin flex would break and I could just get a new battery.Well i lifted the pad...  all of it. Where could I tack a wire to get the +Voltage on the right trace or test point.  I'm not afraid to scrape off some soldermask to find some copper or solder onto one side of a resistor, capacitor, connector, etc....  that voltage has to go to somewhere.  Any chance anyone has photos or better yet a schematic. HA YEAH RIGHT lol

Estatus:

open