Saltar al contenido principal

Aporte original por: Roland Chandler ,


What is the best technique to remove a Shattered screen (digitizer)


After heating the digitizer, I use a thin metal pry tool to lift the screen and then a plectrum and alcohol to release the glue holding down the digitizer.  I have tried putting packing tape, masking tape and 3M clear tape on top the screen to bond the splintered section together to get as much of the screen off in one go, as possible, but the tape does not hold the splintered sections in place.

Getting the screen off in one piece drastically reduces the repair time.

I am going to try some Gorilla Duct Tape next and am even thinking of even trying to bond a screen protector with UV glue

Does any one have any suggestions?