Saltar al contenido principal

Aporte original por: Cody Auch ,


From what you’re describing it sounds like your battery has next to no charge in it. For whatever reason when batteries drop below a certain voltage they lose the ability to be charged through the logic board.  If this is the case the fix is simple: take the battery out of the phone and plug it into a battery activation test charge fixture, if the battery is quite dead it should draw about 1.8A through the  fixture. Allow the battery to charge until it only pulls around 1.0A - 1.2A and then reinstall it back in the phone and plug in the phone. At this point the logic board should detect the battery and begin to charge it.

Since you mentioned water damage it is also possible that there is a short somewhere preventing charging. I would start by checking VCC_MAIN for shorts and going from there