Saltar al contenido principal
Ayuda

Versión actual por: Dan ,

Texto:

Eve Ann Wallis - This series has a unique issue! Apple moved the microphone hole! And in doing so have messed up a few people. You need to modify the bottom tape with a small cut out so the hole is not covered. Here’s the location of the microphone hole:
[image|2154574]
-At this point you should get another adhesive tape kit and after fully cleaning the old tapes off, modify the new set as needed and give that a go!
+At this point you should get another adhesive tape kit and after fully cleaning the old tapes off, modify the new set as needed but cutting a small area at the bottom edge of the strip where the mic is and give that a go!
But, before you put the display back on check your mic cable is connected properly as outlined in step 57 in this guide and the ribbon cable is not damaged [guide|95631]

Estatus:

open

Editado por: Dan ,

Texto:

Eve Ann Wallis - This series has a unique issue! Apple moved the microphone hole! And in doing so have messed up a few people. You need to modify the bottom tape with a small cut out so the hole is not covered. Here’s the location of the microphone hole:
-
-[image|1705221]
[image|2154574]
At this point you should get another adhesive tape kit and after fully cleaning the old tapes off, modify the new set as needed and give that a go!
But, before you put the display back on check your mic cable is connected properly as outlined in step 57 in this guide and the ribbon cable is not damaged [guide|95631]

Estatus:

open

Editado por: Dan ,

Texto:

Eve Ann Wallis - This series has a unique issue! Apple moved the microphone hole! And in doing so have messed up a few people. You need to modify the bottom tape with a small cut out so the hole is not covered. Here’s the location of the microphone hole:
[image|1705221]
+
+[image|2154574]
At this point you should get another adhesive tape kit and after fully cleaning the old tapes off, modify the new set as needed and give that a go!
But, before you put the display back on check your mic cable is connected properly as outlined in step 57 in this guide and the ribbon cable is not damaged [guide|95631]

Estatus:

open

Aporte original por: Dan ,

Texto:

Eve Ann Wallis - This series has a unique issue! Apple moved the microphone hole! And in doing so have messed up a few people. You need to modify the bottom tape with a small cut out so the hole is not covered. Here’s the location of the microphone hole:

[image|1705221]

At this point you should get another adhesive tape kit and after fully cleaning the old tapes off, modify the new set as needed and give that a go!

But, before you put the display back on check your mic cable is connected properly as outlined in step 57 in this guide and the ribbon cable is not damaged [guide|95631]

Estatus:

open