Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Ayuda

Versión actual por: Augustine ,

Texto:

Hi claytonrablin
 
As for me, I had a Hot air SMD rework station and a temperature controlled soldering station.
 
Some would say for temperature controlled station, minimum 60W and above.
 
I prefer those stations to be separated, in event of a failure which will brick all usage. Encountered once when my temperature controlled soldering station heating element is bad. Lucky having the hot air, which is needed to solder the new heating element to the soldering iron.
 
Get good flux, desoldering pumps, etc.
 
A good start.. .Louis Rossmann videos...
 
https://www.youtube.com/watch?v=bVoBZqlvCKo
 
=== Update (01/20/2019) ===
 
Thankyou very much for this fantastic advice. What did you start off soldering ?
 
=== Update (01/20/2019) ===
 
Hi claytonrablin
 
Replacing QFP ethernet chip

Estatus:

open

Editado por: claytonrablin ,

Texto:

Hi claytonrablin
 
As for me, I had a Hot air SMD rework station and a temperature controlled soldering station.
 
Some would say for temperature controlled station, minimum 60W and above.
 
I prefer those stations to be separated, in event of a failure which will brick all usage. Encountered once when my temperature controlled soldering station heating element is bad. Lucky having the hot air, which is needed to solder the new heating element to the soldering iron.
 
Get good flux, desoldering pumps, etc.
 
A good start.. .Louis Rossmann videos...
 
https://www.youtube.com/watch?v=bVoBZqlvCKo
 
=== Update (01/20/2019) ===
 
Thankyou very much for this fantastic advice. What did you start off soldering ?

Estatus:

open

Aporte original por: Augustine ,

Texto:

Hi claytonrablin

As for me, I had a Hot air SMD rework station and a temperature controlled soldering station.

Some would say for temperature controlled station, minimum 60W and above.

I prefer those stations to be separated, in event of a failure which will brick all usage. Encountered once when my temperature controlled soldering station heating element is bad. Lucky having the hot air, which is needed to solder the new heating element to the soldering iron.

Get good flux, desoldering pumps, etc.

A good start.. .Louis Rossmann videos...

https://www.youtube.com/watch?v=bVoBZqlvCKo

Estatus:

open