Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Ayuda

Versión actual por: oldturkey03 ,

Texto:

'''++alfrejdr++'''  per repair manual
 
COMPRESSOR
 
The compressor may be removed and repositioned without disconnecting the refrigerant lines or discharging the refrigerant system. Discharging is not necessary if servicing the compressor clutch or clutch coil, the engine, the cylinder head, or the generator.
 
WARNING: REVIEW THE WARNINGS AND CAUTIONS IN THE FRONT OF THIS GROUP BEFORE PERFORMING THE FOLLOWING OPERATION.
 
REMOVAL
 
(1) Disconnect and isolate the battery negative cable.
 
(2) Loosen and remove the serpentine drive belt.
 
Refer to Group 7 - Cooling System for the procedures.
 
(3) Disconnect the compressor clutch coil wiring.
 
(4) Recover the refrigerant from the refrigerant system as described in this group.
 
(5) Remove the refrigerant lines from the compressor. Install plugs in, or tape over, all of the open refrigerant fittings.
 
(6) Remove the compressor mounting bolts, and lift the compressor from the mounting bracket.
 
For more information use this [document|4904document|4905]
For more information use this [document|4904document|4905]

Estatus:

open

Aporte original por: oldturkey03 ,

Texto:

'''++alfrejdr++'''    per repair manual

COMPRESSOR

The compressor may be removed and repositioned without disconnecting the refrigerant lines or discharging the refrigerant system. Discharging is not necessary if servicing the compressor clutch or clutch coil, the engine, the cylinder head, or the generator.

WARNING: REVIEW THE WARNINGS AND CAUTIONS IN THE FRONT OF THIS GROUP BEFORE PERFORMING THE FOLLOWING OPERATION.

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Loosen and remove the serpentine drive belt.

Refer to Group 7 - Cooling System for the procedures.

(3) Disconnect the compressor clutch coil wiring.

(4) Recover the refrigerant from the refrigerant system as described in this group.

(5) Remove the refrigerant lines from the compressor. Install plugs in, or tape over, all of the open refrigerant fittings.

(6) Remove the compressor mounting bolts, and lift the compressor from the mounting bracket.

For more information use this [document|4904]

Estatus:

open