Saltar al contenido principal
Ayuda

Versión actual por: Mario Tellez ,

Texto:

Your LCS ribbon (plug) isn't clipped on correctly to the board you need to push down till it clips on then slowly and carefully close the screen.
-This is a bit tricky to do because when you lift to put the screen on top everyone makes the mistake of lifting the screen to give you clearance to screen in that top tinny screw and by lifting you unclipped the LCD plug which the metal holds in place and not getting good connection.
+This is a bit tricky to do because when you lift to put the screw on top everyone makes the mistake of lifting the screen to give you clearance to put the tinny screw on the top metal shield and by lifting you unclipped the LCD plug which the metal holds in place and not getting good connection.

Estatus:

open

Aporte original por: Mario Tellez ,

Texto:

Your LCS ribbon (plug) isn't clipped on correctly to the board you need to push down till it clips on then slowly and carefully close the screen.

This is a bit tricky to do because when you lift to put the screen on top everyone makes the mistake of lifting the screen to give you clearance to screen in that top tinny screw and by lifting you unclipped the LCD plug which the metal holds in place and not getting good connection.

Estatus:

open