Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Ayuda

Versión actual por: Clicky Steve ,

Título:

Click wheel electronics transfer or replacement

Texto:

Hello!

I decided to refurb an old iPod 3rd generation, as I like the buttons above the wheel.

I've already swapped out the hard drive and battery, and decided to go the full hog and replace the front panel as well, as the screen was a bit scratched up.

I ordered the front panel, but didn't quite realise that the electronics were separate. There is no guide on how to remove the actual electronics, so before diving in and probably destroying everything, I wondered if anybody had any advice? Anything at all would help.

Dispositivo:

iPod 3rd Generation

Estatus:

open

Respuesta Aceptada:

420338

Aporte original por: Clicky Steve ,

Título:

Click wheel electronics transfer or replacement

Texto:

Hello!

I decided to refurb an old iPod 3rd generation, as I like the buttons above the wheel.

I've already swapped out the hard drive and battery, and decided to go the full hog and replace the front panel as well, as the screen was a bit scratched up.

I ordered the front panel, but didn't quite realise that the electronics were separate. There is no guide on how to remove the actual electronics, so before diving in and probably destroying everything, I wondered if anybody had any advice? Anything at all would help.

Dispositivo:

iPod 3rd Generation

Estatus:

open