Saltar al contenido principal
Ayuda

Versión actual por: vizi0n ,

Título:

iPhone 6 Plus C1267 has a pad that was ripped, where can I tap?

Texto:

While doing a hot air repair, my logic board slipped in my Kaisi holder and one of the screw holder near the LCD assembly slid underneath the metal shield knocking C1267 and C1696 off. I could manage to reinstall C1696 as the pads were intact but C1267 is missing the "bottom" pad (the one next to the black U1501 chip.
 
Where can I tap a wire from to close the circuit? Is this the negative side or positive? Every other caps on that circuit are underneath the logic board :(
 
=== Update (02/03/2017) ===
 
Thnks for your answers. I indeed checked for which pad i have and it seems like the top pad (the one left) is the ground :( I will probably end up selling the good parts as ther might be another issue. Since the "incident" it wont power up at all with the power button or USB (no power drawn on USB). Something might have been damaged/slightly disloged from its place. My home button connector was also dislodged by a retainer on my kaisi and to be replaced. I tried removing it to prevent shorts just in case but it still doesnt power up. Oh well...

Dispositivo:

iPhone 6 Plus

Estatus:

open

Editado por: vizi0n ,

Título:

C1267iPhone 6 Plus C1267 has a pad that was ripped, where can I tap?
C1267iPhone 6 Plus C1267 has a pad that was ripped, where can I tap?

Texto:

While doing a hot air repair, my logic board slipped in my Kaisi holder and one of the screw holder near the LCD assembly slid underneath the metal shield knocking C1267 and C1696 off. I could manage to reinstall C1696 as the pads were intact but C1267 is missing the "bottom" pad (the one next to the black U1501 chip.

Where can I tap a wire from to close the circuit? Is this the negative side or positive? Every other caps on that circuit are underneath the logic board :(

Dispositivo:

iPhone 6 Plus

Estatus:

open

Aporte original por: vizi0n ,

Título:

C1267 has a pad that was ripped, where can I tap?

Texto:

While doing a hot air repair, my logic board slipped in my Kaisi holder and one of the screw holder near the LCD assembly slid underneath the metal shield knocking C1267 and C1696 off. I could manage to reinstall C1696 as the pads were intact but C1267 is missing the "bottom" pad (the one next to the black U1501 chip.

Where can I tap a wire from to close the circuit? Is this the negative side or positive? Every other caps on that circuit are underneath the logic board :(

Dispositivo:

iPhone 6 Plus

Estatus:

open