Saltar al contenido principal
Ayuda

Versión actual por: oldturkey03 (detalles del voto) ,

Título:

Water Damage: Runs on AC, Battery won't charge

Texto:

My MacBook Pro got a bit wet, and now only runs with the MagSafe plugged in. With it plugged in, everything works as expected, but the battery does not charge, and my power source is listed as the power adapter. I have tried replacing the DC-In board for a chance at an inexpensive fix, but the new board shows the same symptoms. I have a feeling it's related to the battery connector to the logic board, as I'm seeing some very slight corrosion on the contacts of the board and can't seem to remove it after trying to clean it with isopropyl and a toothbrush. Below is the Power System Report and the Apple Store Diagnostic indicated a 'Failure' for the battery. I'm debating on replacing the battery or using a Logic Board Damage repair service if this can't be fixed easily. What should I do? Thanks.
Battery Information:
+
* Model Information:
* Serial Number: D865253W2ZTFY5HA7
* Manufacturer: SMP
* Device Name: bq20z451
* Pack Lot Code: 0
* PCB Lot Code: 0
* Firmware Version: 702
* Hardware Revision: 1
* Cell Revision: 3217
* Charge Information:
* Charge Remaining (mAh): 4725
* Fully Charged: No
* Charging: No
* Full Charge Capacity (mAh): 6183
Health Information:
+
* Cycle Count: 71
* Condition: Normal
* Battery Installed: Yes
* Amperage (mA): 0
* Voltage (mV): 12235
System Power Settings:
+
* AC Power:
** System Sleep Timer (Minutes): 1
** Disk Sleep Timer (Minutes): 10
** Display Sleep Timer (Minutes): 10
** Wake on AC Change: No
** Wake on Clamshell Open: Yes
** Wake on LAN: Yes
** AutoPowerOff Delay: 14400
** AutoPowerOff Enabled: 1
** Current Power Source: Yes
** DarkWakeBackgroundTasks: 1
** Display Sleep Uses Dim: Yes
** GPUSwitch: 2
** Hibernate Mode: 3
** PrioritizeNetworkReachabilityOverSleep: 0
** Standby Delay: 10800
** Standby Enabled: 1
* Battery Power:
** System Sleep Timer (Minutes): 1
** Disk Sleep Timer (Minutes): 10
** Display Sleep Timer (Minutes): 2
** Wake on AC Change: No
** Wake on Clamshell Open: Yes
** AutoPowerOff Delay: 14400
** AutoPowerOff Enabled: 1
** DarkWakeBackgroundTasks: 0
** Display Sleep Uses Dim: Yes
** GPUSwitch: 2
** Hibernate Mode: 3
** Reduce Brightness: Yes
** Standby Delay: 10800
** Standby Enabled: 1
Hardware Configuration:
+
* UPS Installed: No
AC Charger Information:
+
* Connected: Yes
* ID: 0x0921
* Wattage (W): 60
* Family: 0x0085
* Serial Number: 0x00b93512
* Charging: No

Dispositivo:

MacBook Pro 13" Retina Display Early 2015

Estatus:

open

Respuesta Aceptada:

+297218

Editado por: Dan ,

Título:

Water Damage: Runs on AC, Battery won't charge

Texto:

My MacBook Pro got a bit wet, and now only runs with the MagSafe plugged in. With it plugged in, everything works as expected, but the battery does not charge, and my power source is listed as the power adapter. I have tried replacing the DC-In board for a chance at an inexpensive fix, but the new board shows the same symptoms. I have a feeling it's related to the battery connector to the logic board, as I'm seeing some very slight corrosion on the contacts of the board and can't seem to remove it after trying to clean it with isopropyl and a toothbrush. Below is the Power System Report and the Apple Store Diagnostic indicated a 'Failure' for the battery. I'm debating on replacing the battery or using a Logic Board Damage repair service if this can't be fixed easily. What should I do? Thanks.
Battery Information:
-
-Model Information:
-
-Serial Number: D865253W2ZTFY5HA7
-
-Manufacturer: SMP
-
-Device Name: bq20z451
-
-Pack Lot Code: 0
-
-PCB Lot Code: 0
-
-Firmware Version: 702
-
-Hardware Revision: 1
-
-Cell Revision: 3217
-
-Charge Information:
-
-Charge Remaining (mAh): 4725
-
-Fully Charged: No
-
-Charging: No
-
-Full Charge Capacity (mAh): 6183
+* Model Information:
+* Serial Number: D865253W2ZTFY5HA7
+* Manufacturer: SMP
+* Device Name: bq20z451
+* Pack Lot Code: 0
+* PCB Lot Code: 0
+* Firmware Version: 702
+* Hardware Revision: 1
+* Cell Revision: 3217
+* Charge Information:
+* Charge Remaining (mAh): 4725
+* Fully Charged: No
+* Charging: No
+* Full Charge Capacity (mAh): 6183
Health Information:
-
-Cycle Count: 71
-
-Condition: Normal
-
-Battery Installed: Yes
-
-Amperage (mA): 0
-
-Voltage (mV): 12235
+* Cycle Count: 71
+* Condition: Normal
+* Battery Installed: Yes
+* Amperage (mA): 0
+* Voltage (mV): 12235
System Power Settings:
-
-AC Power:
-
-System Sleep Timer (Minutes): 1
-
-Disk Sleep Timer (Minutes): 10
-
-Display Sleep Timer (Minutes): 10
-
-Wake on AC Change: No
-
-Wake on Clamshell Open: Yes
-
-Wake on LAN: Yes
-
-AutoPowerOff Delay: 14400
-
-AutoPowerOff Enabled: 1
-
-Current Power Source: Yes
-
-DarkWakeBackgroundTasks: 1
-
-Display Sleep Uses Dim: Yes
-
-GPUSwitch: 2
-
-Hibernate Mode: 3
-
-PrioritizeNetworkReachabilityOverSleep: 0
-
-Standby Delay: 10800
-
-Standby Enabled: 1
-
-Battery Power:
-
-System Sleep Timer (Minutes): 1
-
-Disk Sleep Timer (Minutes): 10
-
-Display Sleep Timer (Minutes): 2
-
-Wake on AC Change: No
-
-Wake on Clamshell Open: Yes
-
-AutoPowerOff Delay: 14400
-
-AutoPowerOff Enabled: 1
-
-DarkWakeBackgroundTasks: 0
-
-Display Sleep Uses Dim: Yes
-
-GPUSwitch: 2
-
-Hibernate Mode: 3
-
-Reduce Brightness: Yes
-
-Standby Delay: 10800
-
-Standby Enabled: 1
+* AC Power:
+** System Sleep Timer (Minutes): 1
+** Disk Sleep Timer (Minutes): 10
+** Display Sleep Timer (Minutes): 10
+** Wake on AC Change: No
+** Wake on Clamshell Open: Yes
+** Wake on LAN: Yes
+** AutoPowerOff Delay: 14400
+** AutoPowerOff Enabled: 1
+** Current Power Source: Yes
+** DarkWakeBackgroundTasks: 1
+** Display Sleep Uses Dim: Yes
+** GPUSwitch: 2
+** Hibernate Mode: 3
+** PrioritizeNetworkReachabilityOverSleep: 0
+** Standby Delay: 10800
+** Standby Enabled: 1
+* Battery Power:
+** System Sleep Timer (Minutes): 1
+** Disk Sleep Timer (Minutes): 10
+** Display Sleep Timer (Minutes): 2
+** Wake on AC Change: No
+** Wake on Clamshell Open: Yes
+** AutoPowerOff Delay: 14400
+** AutoPowerOff Enabled: 1
+** DarkWakeBackgroundTasks: 0
+** Display Sleep Uses Dim: Yes
+** GPUSwitch: 2
+** Hibernate Mode: 3
+** Reduce Brightness: Yes
+** Standby Delay: 10800
+** Standby Enabled: 1
Hardware Configuration:
-
-UPS Installed: No
+* UPS Installed: No
AC Charger Information:
-
-Connected: Yes
-
-ID: 0x0921
-
-Wattage (W): 60
-
-Family: 0x0085
-
-Serial Number: 0x00b93512
-
-Charging: No
+* Connected: Yes
+* ID: 0x0921
+* Wattage (W): 60
+* Family: 0x0085
+* Serial Number: 0x00b93512
+* Charging: No

Dispositivo:

MacBook Pro 13" Retina Display Early 2015

Estatus:

open

Aporte original por: spentsr ,

Título:

Water Damage: Runs on AC, Battery won't charge

Texto:

My MacBook Pro got a bit wet, and now only runs with the MagSafe plugged in. With it plugged in, everything works as expected, but the battery does not charge, and my power source is listed as the power adapter. I have tried replacing the DC-In board for a chance at an inexpensive fix, but the new board shows the same symptoms. I have a  feeling it's related to the battery connector to the logic board, as I'm seeing some very slight corrosion on the contacts of the board and can't seem to remove it after trying to clean it with isopropyl and a toothbrush. Below is the Power System Report and the Apple Store Diagnostic indicated a 'Failure' for the battery. I'm debating on replacing the battery or using a Logic Board Damage repair service if this can't be fixed easily. What should I do? Thanks.

Battery Information:

Model Information:

Serial Number:    D865253W2ZTFY5HA7

Manufacturer:    SMP

Device Name:    bq20z451

Pack Lot Code:    0

PCB Lot Code:    0

Firmware Version:    702

Hardware Revision:    1

Cell Revision:    3217

Charge Information:

Charge Remaining (mAh):    4725

Fully Charged:    No

Charging:    No

Full Charge Capacity (mAh):    6183

Health Information:

Cycle Count:    71

Condition:    Normal

Battery Installed:    Yes

Amperage (mA):    0

Voltage (mV):    12235

System Power Settings:

AC Power:

System Sleep Timer (Minutes):    1

Disk Sleep Timer (Minutes):    10

Display Sleep Timer (Minutes):    10

Wake on AC Change:    No

Wake on Clamshell Open:    Yes

Wake on LAN:    Yes

AutoPowerOff Delay:    14400

AutoPowerOff Enabled:    1

Current Power Source:    Yes

DarkWakeBackgroundTasks:    1

Display Sleep Uses Dim:    Yes

GPUSwitch:    2

Hibernate Mode:    3

PrioritizeNetworkReachabilityOverSleep:    0

Standby Delay:    10800

Standby Enabled:    1

Battery Power:

System Sleep Timer (Minutes):    1

Disk Sleep Timer (Minutes):    10

Display Sleep Timer (Minutes):    2

Wake on AC Change:    No

Wake on Clamshell Open:    Yes

AutoPowerOff Delay:    14400

AutoPowerOff Enabled:    1

DarkWakeBackgroundTasks:    0

Display Sleep Uses Dim:    Yes

GPUSwitch:    2

Hibernate Mode:    3

Reduce Brightness:    Yes

Standby Delay:    10800

Standby Enabled:    1

Hardware Configuration:

UPS Installed:    No

AC Charger Information:

Connected:    Yes

ID:    0x0921

Wattage (W):    60

Family:    0x0085

Serial Number:    0x00b93512

Charging:    No

Dispositivo:

MacBook Pro 13" Retina Display Early 2015

Estatus:

open