Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Ayuda

Versión actual por: phunguss ,

Texto:

Since the resurrected motherboard I have is going into a cube case and was missing the original heat sink, this alternate was held in place with zip ties.
 
I just used small zip ties about 3-4 inches long. Ran one down from the top then back up from the bottom... and used a second one to bridge across. Add two more for the other set of holes. Not spring loaded, but holds it on there with no problem.
 
[image|502591|align=left]
 
=== Update (11/15/2017) ===
 
Zip ties with original springs: [image|1260266]
[image|1260265]

Estatus:

open

Aporte original por: phunguss ,

Texto:

Since the resurrected motherboard I have is going into a cube case and was missing the original heat sink, this alternate was held in place with zip ties.

I just used small zip ties about 3-4 inches long.  Ran one down from the top then back up from the bottom... and used a second one to bridge across.  Add two more for the other set of holes.  Not spring loaded, but holds it on there with no problem.

[image|502591|align=left]

Estatus:

open