Saltar al contenido principal
Ayuda

Versión actual por: Dan ,

Texto:

Well you're lucky here! you only pulled off the cable connector and did not damage the logic board connector (you'll need to carefully remove the remaining cable connector piece) while not the best picture look at this: [https://d3nevzfk7ii3be.cloudfront.net/igi/RFP1wZ61QvypEeeF|Removed iSight cable connector]. Thats the good news! Now the bad ;-{
Well you're lucky here! you only pulled off the cable connector and did not damage the logic board connector (you'll need to carefully remove the remaining cable connector piece) while not the best picture look at this: [https://d3nevzfk7ii3be.cloudfront.net/igi/RFP1wZ61QvypEeeF|Removed iSight cable connector]. Thats the good news! Now the bad ;-{
 
To replace the cable you'll need to take the display off and then dissemble it. This is a very big job! And you do need to be more careful. Instead of going that deep you could replace the full lid assembly while more expensive it will be a lot easier! Here is the steps to pulling off the display assembly: [guide|5140|MacBook Pro 13" Unibody Early 2011 Display Replacement].
 
You'll need to refer to this guide to give you an idea how to disassemble the display the rest of the way: [guide|1423|MacBook Pro 13" Unibody Mid 2009 LCD Replacement] Jump to Step 15, so you can get the cable connection on the displays logic board. The next issue is finding the cable which will be difficult.

Estatus:

open

Aporte original por: Dan ,

Texto:

Well you're lucky here! you only pulled off the cable connector and did not damage the logic board connector while not the best picture look at this: [https://d3nevzfk7ii3be.cloudfront.net/igi/RFP1wZ61QvypEeeF|Removed iSight cable connector]. Thats the good news! Now the bad ;-{

To replace the cable you'll need to take the display off and then dissemble it. This is a very big job! And you do need to be more careful. Instead of going that deep you could replace the full lid assembly while more expensive it will be a lot easier! Here is the steps to pulling off the display assembly: [guide|5140|MacBook Pro 13" Unibody Early 2011 Display Replacement].

You'll need to refer to this guide to give you an idea how to disassemble the display the rest of the way: [guide|1423|MacBook Pro 13" Unibody Mid 2009 LCD Replacement] Jump to Step 15, so you can get the cable connection on the displays logic board. The next issue is finding the cable which will be difficult.

Estatus:

open