3 de dic. de 2012
Texto:
stuart, here is what the service manual suggest : Open the oven door as wide as possible. + Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1, + Remove the screws from each side with a Phillips screwdriver. + Remove the lock plate from each side, Figure 2-1 + Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin. + Grasp the door toward the top on both sides. Lift the door up and out to remove. - [image|212626] + [image|212626|align=center ] "SERVICING OVEN DOOR 1. Lay the oven door on a protected surface with the inner door panel facing down. 2. Remove three screws from lower trim.Remove trim piece. 3. Slide outer-door glass down to disengage from top trim. Remove. 4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket. 5. Lift up and off. This will disengage the side trim as well. 6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer." Hope this helps, good luck.
Estatus:
open
3 de dic. de 2012
Texto:
stuart, here is what the service manual suggest : + + Open the oven door as wide as possible. + Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1, + Remove the screws from each side with a Phillips screwdriver. + Remove the lock plate from each side, Figure 2-1 + Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin. + Grasp the door toward the top on both sides. Lift the door up and out to remove. + + [image|212626] "SERVICING OVEN DOOR 1. Lay the oven door on a protected surface with the inner door panel facing down. 2. Remove three screws from lower trim.Remove trim piece. 3. Slide outer-door glass down to disengage from top trim. Remove. 4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket. 5. Lift up and off. This will disengage the side trim as well. 6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer." Hope this helps, good luck.
Estatus:
open
3 de dic. de 2012
Texto:
stuart, here is what the service manual suggest :
"SERVICING OVEN DOOR
1. Lay the oven door on a protected surface with the inner door panel facing down.
2. Remove three screws from lower trim.Remove trim piece.
3. Slide outer-door glass down to disengage from top trim. Remove.
4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.
5. Lift up and off. This will disengage the side trim as well.
6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."
Hope this helps, good luck.
Estatus:
open