por que el deck del casette no cierra

⟐ Edited by author junio 17, 2025 at 10:38 GMT-7

⟐ Answered abril 14, 2025 at 7:24 GMT-7

⟐ Edited by author febrero 24, 2025 at 17:45 GMT-7

⟐ Answered febrero 21, 2025 at 10:40 GMT-7

La videocámara graba perfectamente en función de cámara, pero solo reproduce las cintas utilizando el mando a distancia, y el zoom también funciona con el mando.

En el servicio Sony me dicen que ya no reparan estás cámaras porque ya no tienen componentes y me da pena porque está videocámara hace unas grabaciones en sistema Pal muy buenas, tiene sonido estéreo y una lente de las que ya casi no fabrican.

Si me pueden dar alguna solución sobre qué puede ser la avería porque no llevo ningún golpe.

Está prácticamente nueva.

Saludos.

⟐ Answer edited septiembre 23, 2024 at 19:42 GMT-7

⟐ Answered julio 01, 2024 at 22:56 GMT-7

⟐ Answered junio 04, 2024 at 15:22 GMT-7

⟐ Answered enero 27, 2024 at 12:48 GMT-7

⟐ Answer edited junio 18, 2023 at 9:12 GMT-7

exsite alguna opcion para reiniciarla?

Loose Ribbon cable that effected the camera, full disassembly is required and inspection if you are getting "white noise"/a pink fuzzy screen on you Camcorder!

⟐ Edited by author julio 02, 2026 at 18:23 GMT-7

I am trying to revive an old Sony CCD-TR425E PAL camcorder, but it does not fully work.

• The side-display works, but shows only battery readings / charging.
• Able to charge the battery.
• Able to eject the cassette compartment.
• Able to perform aforementioned functions without the battery when connected to the power cord.
• Able to perform aforementioned functions using the battery when not connected to the power cord.

So it has some semblance of life, but not enough to be operational.

Fig 1: Sony CCD-TR425E PAL camcorder side-display showing battery readings.

• Cannot record / play a cassette.
• Does not make any mechanical noises of attempting to play a cassette after insertion / attempted playback. (Except for closing the cassette compartment)
• No image in the viewfinder display.
• The side-display does not show anything except battery readings.
• Cannot access menus or settings.
• Cannot enter service mode / cannot display service-mode diagnostic codes.

• Replaced the coin cell battery.
• Replaced the main battery.
• The external AC adapter / charger outputs the correct voltage (8.4 V).
• The battery is receiving charge (charges to 8.2 V, within spec)
• (Failed) Attempted to enter self-diagnostic mode.
• (Failed) Attempted to play back / record from a cassette.

How should I continue troubleshooting this?

When reading on Reddit, some folks mention for similar models that it is common for a fuse to fail (without mentioning specifics). Looking at a similar question here on iFixit I found this QnA also mentioning a fuse.

So I found the service manual and schematics, looking at the power board (board DD-117, page section 4-109 to 4-112E, p. 84 in pdf reader) I found the following fuses in the schematic:

• PS801 (BAT_UNREG)
• PS802
• PS803 (VTR_UNREG)
• PS804
• PS805 (may not exist on my model)
• PS106
• PS107

Fig 2: DD-117 schematic electrical diagram, p.84, particular fuses are in the area B-11 to C-13, marked orange in the figure.

I can confirm on p. 83 in pdf reader (page section 4-106 to 4-108) with the SMD overview that those are all the fuses on the power board.

Is my next step to disassemble the camcorder and use my multimeter to test all the fuses?
I will also look around for any obvious damaged / burnt components too during disassembly.
Is there anything I should do before I disassemble the camcorder?
Is there anything else I should do when dismantling the camcorder, besides testing the the fuses?

Thanks in advance,
Cheers.

⟐ Commented junio 29, 2026 at 11:24 GMT-7

⟐ Commented junio 07, 2026 at 11:13 GMT-7

I have a capture device to transfer tapes to digital, but I'm having a problem with the cables. The camcorder has a black and yellow cable, which the capture device also has. The problem is that the black cable for capture device isn't the same as the black for the camera, seen in the photos. Is there any cable I could buy to link these together?

⟐ Answered mayo 11, 2026 at 11:25 GMT-7