Saltar al contenido principal
Ayuda

Ediciones pendientes de Logitech C920 Webcam Disassembly

EN

Nota: al aceptar o rechazar una edición, esto se aplicará a todas las ediciones pendientes del mismo paso o introducción.

Paso #12 editado: [Paso editado]

Editado el por Troy weglinski (449)

(No tienes reputación suficiente para patrullar esta edición.)

Texto de Origen

0-black-O cabo recuperado foi montado na câmera. Revesti-o com uma fita crepe. Câmera testada: OK !
0-black-Remonte a câmera seguindo o procedimento na ordem inversa.
-[* black] The repaired cable was attached to the camera. Coated it with some masking tape. Camera tested: OK!
+[* black] The repaired cable is reattached to the camera. Wrapped it with some masking tape. Camera tested: OK!
[* black] Assemble the webcam following the steps in a reverse order.


Paso #11 editado: [Paso editado]

Editado el por Troy weglinski (449)

(No tienes reputación suficiente para patrullar esta edición.)

Texto de Origen

0-black-O problema da webcam era o cabo partido, na parte traseira da câmera. Cortei a parte com defeito e refiz as ligações com solda e isolei com tubos (espaguetes) termorretráteis.
-[* black] The problem was the broken cable on the back of the camera. I've cut the faulty part and redid the connections by welding them and insulated them with heat shrinking tubes.
+[* black] The problem was the broken cable on the back of the camera. I've cut the faulty part and redid the connections by soldering them and insulated them with heat shrink tubes.


Paso #4 editado: [Paso editado]

Editado el por Troy weglinski (449)

(No tienes reputación suficiente para patrullar esta edición.)

Texto de Origen

0-black-Remova a tampa cristalina da lente.
0-light_blue-Remova os cinco parafusos Philips do suporte de metal.
0-black-Remova as borrachas dos dois microfones (uma de cada lado).
-[* black] Remove the lens's crystal cover.
+[* black] Remove the lens's cover.
[* light_blue] Remove the five Phillips screws of the metal bracket.
-[* black] Remove the rubbers of both microphones (one on each side).
+[* black] Remove the rubber pieces of both microphones (one on each side).