Introducción
Use this guide to replace a faulty camera board.
Qué necesitas
-
Herramienta utilizada en este paso:Heavy-Duty Suction Cups (Pair)$14.95
-
Stick a heavy-duty suction cup near each of the two top corners of the glass panel.
-
While lightly holding the suction cup against the glass, raise the movable handle until it is parallel with the other handle (as indicated by the third picture).
-
-
-
-
Remove the two T10 Torx screws securing the camera board to the outer case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
Un comentario
Tedious as heck, but better than plopping a USB camera on the top or on the side. :-)