Saltar al contenido principal

iBook G3 12" LCD Replacement

Qué necesitas

  1. iBook G3 12" LCD Replacement, Battery: paso 1, imagen 1 de 1
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

  2. iBook G3 12" LCD Replacement, Rear Display Bezel: paso 2, imagen 1 de 2 iBook G3 12" LCD Replacement, Rear Display Bezel: paso 2, imagen 2 de 2
    • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  3. iBook G3 12" LCD Replacement: paso 3, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 3, imagen 2 de 2
    • Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.

    • Rotate the spudger away from the display to pry the rear bezel off the front bezel.

  4. iBook G3 12" LCD Replacement: paso 4, imagen 1 de 1
    • Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

  5. iBook G3 12" LCD Replacement: paso 5, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 5, imagen 2 de 2
    • Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

  6. iBook G3 12" LCD Replacement: paso 6, imagen 1 de 1
    • Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.

    • If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

  7. iBook G3 12" LCD Replacement: paso 7, imagen 1 de 1
    • Lift the rear bezel off the display assembly.

  8. iBook G3 12" LCD Replacement, LCD: paso 8, imagen 1 de 2 iBook G3 12" LCD Replacement, LCD: paso 8, imagen 2 de 2
    • Close the display.

    • Remove the small pieces of yellow tape securing the thin metal LCD cover to the display.

    • Remove the large piece of tape near the right display hinge.

  9. iBook G3 12" LCD Replacement: paso 9, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 9, imagen 2 de 2
    • Remove the tape covering the inverter cable connector.

    • Remove the piece of foil tape near the center of the thin metal LCD cover.

  10. iBook G3 12" LCD Replacement: paso 10, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 10, imagen 2 de 2
    • Remove the Phillips screw near the right display hinge.

    • Use the tip of a spudger to remove the small spacer under the screw you just removed.

  11. iBook G3 12" LCD Replacement: paso 11, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 11, imagen 2 de 2
    • Pull the foil/braided pieces of tape off the aluminum frame of the clutch hinges. Leave the tape attached to the thin steel LCD cover.

    • Remove the small piece of tape holding the display data cable ground strap to the LCD cover.

  12. iBook G3 12" LCD Replacement: paso 12, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 12, imagen 2 de 2
    • Remove the two Phillips screws securing the left and right sides of the LCD to the frame of the clutch hinges (four screws total).

  13. iBook G3 12" LCD Replacement: paso 13, imagen 1 de 1
    • Carefully remove the thin steel LCD cover.

  14. iBook G3 12" LCD Replacement: paso 14, imagen 1 de 2 iBook G3 12" LCD Replacement: paso 14, imagen 2 de 2
    • Remove the long piece of tape securing the display data cable to the LCD.

    • Disconnect the display data cable by pulling the cable away from the socket on the LCD.

  15. iBook G3 12" LCD Replacement: paso 15, imagen 1 de 1
    • Disconnect the backlight cable from the inverter.

    • It is helpful to use a spudger to push the backlight connector away from its socket while you lightly pull its cables away from the inverter.

  16. iBook G3 12" LCD Replacement: paso 16, imagen 1 de 3 iBook G3 12" LCD Replacement: paso 16, imagen 2 de 3 iBook G3 12" LCD Replacement: paso 16, imagen 3 de 3
    • Open the display.

    • Lift the LCD out of the display assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

12 personas más completaron esta guía.

Documentos Adjuntos

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 3

Ultimos 30 días: 13

Todo El Tiempo: 11,287