Introducción

This is a repair guide for battery replacement.

To reach the battery, follow steps 1 through 3 in the Tungsten E Teardown

Agregar Comentario

Begin to pry up the battery.  It is fastened to the mother board using two sided tape.
  • Begin to pry up the battery. It is fastened to the mother board using two sided tape.

  • Caution: the battery is connected by two wires.

Agregar Comentario

Remove the battery
  • Remove the battery

  • Caution: Be careful not to tear the wires when removing battery.

Agregar Comentario

Using a soldering iron, disconnect the battery wires.
  • Using a soldering iron, disconnect the battery wires.

  • Note: the wires are soldered to the board.

Agregar Comentario

Take replacement battery and solder the wires to the board.
  • Take replacement battery and solder the wires to the board.

  • Take care to match wire colors as before.

  • Use double sided tape to attach battery firmly to board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Kathleen Hix

Miembro Desde 21/01/10

49 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 13-22, Maness Winter 2010 Miembro de Cal Poly, Team 13-22, Maness Winter 2010

CPSU-MANESS-W10S13G22

4 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 14

Todo El Tiempo: 5,621