Saltar al contenido principal

Toshiba Satellite U405D-S2902 Display Replacement

Qué necesitas

  1. Toshiba Satellite U405D-S2902 Display Replacement, Display: paso 1, imagen 1 de 1
    • Use tweezers to remove the small rubber covers over the screws on the top and bottom of the laptop case.

  2. Toshiba Satellite U405D-S2902 Display Replacement: paso 2, imagen 1 de 2 Toshiba Satellite U405D-S2902 Display Replacement: paso 2, imagen 2 de 2
    • Use a #1 Phillips screwdriver to remove the 3mm screws located on both sides of the top of the laptop as well as the lower corners.

  3. Toshiba Satellite U405D-S2902 Display Replacement: paso 3, imagen 1 de 3 Toshiba Satellite U405D-S2902 Display Replacement: paso 3, imagen 2 de 3 Toshiba Satellite U405D-S2902 Display Replacement: paso 3, imagen 3 de 3
    • Use a plastic opening tool to separate the front plastic panel from the back side of the top of the laptop.

    • Carefully pull the top away from the back.

  4. Toshiba Satellite U405D-S2902 Display Replacement: paso 4, imagen 1 de 3 Toshiba Satellite U405D-S2902 Display Replacement: paso 4, imagen 2 de 3 Toshiba Satellite U405D-S2902 Display Replacement: paso 4, imagen 3 de 3
    • Turn the laptop around.

    • Remove the webcam/microphone data cable.

  5. Toshiba Satellite U405D-S2902 Display Replacement: paso 5, imagen 1 de 2 Toshiba Satellite U405D-S2902 Display Replacement: paso 5, imagen 2 de 2
    • Remove the lower lighting power supply.

    • Remove the signal light power supply and data cable.

  6. Toshiba Satellite U405D-S2902 Display Replacement: paso 6, imagen 1 de 2 Toshiba Satellite U405D-S2902 Display Replacement: paso 6, imagen 2 de 2
    • Locate and remove the four 2mm #1 Phillips screws around the sidewalls of the display.

    • After removing the last screw, the screen will be very loose, be sure to keep a hand on it to prevent it from damaging the keyboard.

  7. Toshiba Satellite U405D-S2902 Display Replacement: paso 7, imagen 1 de 2 Toshiba Satellite U405D-S2902 Display Replacement: paso 7, imagen 2 de 2
    • Carefully remove the screen from the side brackets.

    • Remove the LCD ribbon connector from the display.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Equipo

Cal Poly, Team 7-8, Maness Winter 2013 Miembro de Cal Poly, Team 7-8, Maness Winter 2013

CPSU-MANESS-W13S7G8

4 Miembros

8 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 681