Repara tus cosas Comunidad Tienda

TiVo Series 2 TCD540080 Power Supply Replacement

Qué necesitas

  1. TiVo Series 2 TCD540080 Power Supply Replacement, Removal of TiVo Series 2 TCD540080 Case: paso 1, imagen 1 de 1

    • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

    Traducir

  2. TiVo Series 2 TCD540080 Power Supply Replacement: paso 2, imagen 1 de 1

    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

    Traducir

  3. TiVo Series 2 TCD540080 Power Supply Replacement: paso 3, imagen 1 de 2 TiVo Series 2 TCD540080 Power Supply Replacement: paso 3, imagen 2 de 2

    • Lift up and pull back the outer casing towards the rear of the unit.

    Traducir

  5. TiVo Series 2 TCD540080 Power Supply Replacement, Power Supply: paso 4, imagen 1 de 2 TiVo Series 2 TCD540080 Power Supply Replacement, Power Supply: paso 4, imagen 2 de 2

    • Carefully remove the ribbon cable from the power supply. Hold the ribbon on both sides and pull up.

    Traducir

  6. TiVo Series 2 TCD540080 Power Supply Replacement: paso 5, imagen 1 de 1

    • Disconnect the hard drive power cable. Firmly grip the white power connector and pull away from the hard drive.

    • Do not pull on the power cables when disconnecting power connector.

    Traducir

  7. TiVo Series 2 TCD540080 Power Supply Replacement: paso 6, imagen 1 de 1

    • Rotate the device 180 degrees and remove the two T10 screws from the power supply board.

    Traducir

  8. TiVo Series 2 TCD540080 Power Supply Replacement: paso 7, imagen 1 de 2 TiVo Series 2 TCD540080 Power Supply Replacement: paso 7, imagen 2 de 2

    • Remove the four plastic standoffs.

    • Use pliers to squeeze the plastic pieces on the head together. Carefully press down on the standoff and pull up on the power supply.

    Traducir

  9. TiVo Series 2 TCD540080 Power Supply Replacement: paso 8, imagen 1 de 2 TiVo Series 2 TCD540080 Power Supply Replacement: paso 8, imagen 2 de 2

    • Lift the power supply out of the unit.

    • Do not touch any circuit elements or capacitors on the power supply, as they may hold a charge after the unit has been shut off.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 9 otros colaboradores

Svyatoslav Markeyev

Miembro Desde 04/16/10

135 Reputación

5 Guías creadas

Insignias: 8

+ 5 más insignias

Equipo

Cal Poly, Team 33-79, Johann Spring 2010 Miembro de Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 5,160