Saltar al contenido principal

Sony Handycam DCR-DVD103 Outer Cover Replacement

Qué necesitas

  1. Sony Handycam DCR-DVD103 Outer Cover Replacement, Battery: paso 1, imagen 1 de 1
    • Images do not show the camera's battery.

    • On the back of the camera beneath the viewfinder, locate the battery pack.

    • Press the small button.

    • Slide the switch forward.

  2. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 2, imagen 1 de 1
    • Remove the battery from the camera.

    • To reinsert the battery, slide the battery into the camera.

  3. Sony Handycam DCR-DVD103 Outer Cover Replacement, Outer Cover: paso 3, imagen 1 de 1
    • Using a #00 Phillips screwdriver, remove the six 4.5 mm screws from the camera's bottom.

  4. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 4, imagen 1 de 2 Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 4, imagen 2 de 2
    • Remove the three 4.5 mm screws beneath the battery.

    • Remove the 2.9 mm screw from the right corner.

    • Remove the two 4.5 mm screws from the battery's right wall.

    • Images do not show the battery.

  5. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 5, imagen 1 de 1
    • Remove the 4.5 mm screw under the output flap on the front of the camera below the lens.

  6. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 6, imagen 1 de 2 Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 6, imagen 2 de 2
    • Remove the two 4.5 mm screws at the top of the camera.

    • Remove the 4.5 mm screw from the disk side of the camera (next to the lens).

  7. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 7, imagen 1 de 2 Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 7, imagen 2 de 2
    • Extend the gray viewfinder, then gently remove the black plastic casing.

    • Caution: Plastic pieces are fragile.

  8. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 8, imagen 1 de 1
    • Remove the two 2.9 mm screws under the black plastic casing.

  9. Sony Handycam DCR-DVD103 Outer Cover Replacement: paso 9, imagen 1 de 1
    • Gently pull apart the outer silver case and screen.

    • Remove the copper wire strip to detach the case from the camera.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

kaitlin

Miembro Desde 01/11/11

342 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 7-44, Regan Winter 2011 Miembro de Cal Poly, Team 7-44, Regan Winter 2011

CPSU-REGAN-W11S7G44

5 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 2,438