Introducción

The camera will need to be completely disassembled to get to the flash, so only do this as as a last resort.

Open the battery compartment and remove the batteries.
  • Open the battery compartment and remove the batteries.

  • Remove all of the visible screws on the outside of the case.

  • There should be three of them that are all easily located.

Agregar Comentario

Open the memory card compartment.
  • Open the memory card compartment.

  • Remove the screw next to the memory card slot.

Agregar Comentario

Pull apart the front and back cover pieces carefully.
  • Pull apart the front and back cover pieces carefully.

  • The front cover should come completely free with little effort.

  • The back cover will still be attached to the circuit board.

Agregar Comentario

Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
  • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

  • The circuitry will still be connected to the back case by ribbon cables.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Open the case as shown.
  • Open the case as shown.

Agregar Comentario

Unclip the clip holding the ribbon cable in.
  • Unclip the clip holding the ribbon cable in.

  • Other ribbon cables might not have a clips.

Agregar Comentario

Pull the ribbon cable out.
  • Pull the ribbon cable out.

Agregar Comentario

Remove all six screws on the front side of the motherboard circled in the picture.
  • Remove all six screws on the front side of the motherboard circled in the picture.

  • Pull the motherboard from the rest of the housing.

  • It will still be connected to the flash unit.

Agregar Comentario

Remove the cable on the back side of the motherboard.
  • Remove the cable on the back side of the motherboard.

Agregar Comentario

Detach the ribbon cables shown.
  • Detach the ribbon cables shown.

  • Careful! Touching the leads of the large yellow capacitor can result in a painful shock.

  • Remove the flash unit from the motherboard.

Agregar Comentario

Discharge the yellow capacitor attached to the flash unit by shorting the leads with a screw driver.
  • Discharge the yellow capacitor attached to the flash unit by shorting the leads with a screw driver.

  • Avoid touching the leads with your hands, as this can result in a painful shock.

Discharge the yellow capacitor attached to the flash unit by shorting the leads with a screw driver having a non-conductive handle.

Stephen Daugherty - Contestar

Replace the flash unit.
  • Replace the flash unit.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Trevor

Miembro Desde 20/01/11

277 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 3-43, Regan Winter 2011 Miembro de Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,594