Partes

No se requieren partes.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Agregar Comentario

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Agregar Comentario

Romove 1 screw from thumb dial panel on the righ side of the device.
  • Romove 1 screw from thumb dial panel on the righ side of the device.

Agregar Comentario

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Agregar Comentario

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Romove 2 screws from the bottom of the device.
  • Romove 2 screws from the bottom of the device.

Agregar Comentario

Remove the thumb dial panel by sliding it away from the device.  (note: you can do this step earlier after you remove all screws from thumb drive panel)
  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Agregar Comentario

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Agregar Comentario

Remove 1 screw located on board below battery.
  • Remove 1 screw located on board below battery.

Agregar Comentario

Unplug male battery plug on the battery wire from the female battery plug on the board.
  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Agregar Comentario

remove the battery from the device by sliding it out of the side of the device
  • remove the battery from the device by sliding it out of the side of the device

Agregar Comentario

slide new battery under the board from the side of the device.
  • slide new battery under the board from the side of the device.

Agregar Comentario

Plug battery back into board.
  • Plug battery back into board.

Agregar Comentario

Place screw back into board.
  • Place screw back into board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Rob

Miembro Desde 04/10/11

1 Reputación

2 Guías creadas

Equipo

UW Stout, Team 5-6, Zhou Fall 2011 Miembro de UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Miembros

2 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 3

Todo El Tiempo: 1,440