Introducción

This guide will detail the steps necessary to remove the back cover of the Sony Bloggie 3D Player.

Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
  • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

Agregar Comentario

Use a plastic opening tool to pry the cover open. After the the cover is partly open as shown, remove the cover with your hands.
  • Use a plastic opening tool to pry the cover open.

  • After the the cover is partly open as shown, remove the cover with your hands.

Agregar Comentario

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board. Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.
  • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

Agregar Comentario

Use a plastic opening tool to loosen the back cover off the device. Once the back cover is loose, remove it gently by hand.
  • Use a plastic opening tool to loosen the back cover off the device.

  • Once the back cover is loose, remove it gently by hand.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Timothy Tran

Miembro Desde 30/01/13

1 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 7-12, Maness Winter 2013 Miembro de Cal Poly, Team 7-12, Maness Winter 2013

CPSU-MANESS-W13S7G12

5 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 263