Repara tus cosas Comunidad Tienda

Shure SM58 XLR Connector Replacement

Introducción

The XLR connector is the place where the XLR cable connects to the microphone. If the connector is pulled out, the internal wiring of the microphone can be damaged.

Qué necesitas

  1. Shure SM58 XLR Connector Replacement, Connector: paso 1, imagen 1 de 3 Shure SM58 XLR Connector Replacement, Connector: paso 1, imagen 2 de 3 Shure SM58 XLR Connector Replacement, Connector: paso 1, imagen 3 de 3

    • While holding the microphone connector in one hand, and the XLR cable in the other hand, slowly pull them apart.

    • Make sure you are not holding the microphone connector by the wires.

    • Check to make sure all of the internal wires are connected. If you see a disconnected wire, take a look at the connector soldering guide.

    Traducir

  2. Shure SM58 XLR Connector Replacement: paso 2, imagen 1 de 2 Shure SM58 XLR Connector Replacement: paso 2, imagen 2 de 2

    • Hold the microphone connector in one hand and the microphone base in the other.

    • Line up the screw in the connector with the hole in the middle of the microphone.

    • Also, align the ridge on the microphone connector (located near the top of the connector) with the slot in the base of the microphone.

    Traducir

  4. Shure SM58 XLR Connector Replacement: paso 3, imagen 1 de 2 Shure SM58 XLR Connector Replacement: paso 3, imagen 2 de 2

    • With those parts aligned, push the connector back into the microphone until the screw lines up with hole in the side of the microphone.

    • Do not push the microphone past this point or the connector may become stuck.

    Traducir

  5. Shure SM58 XLR Connector Replacement: paso 4, imagen 1 de 1

    • Using a small flat head screw driver, turn the screw in the side of the microphone clockwise until it is tight.

    Traducir
Conclusión

Following these steps should reinstall the XLR connector back into the microphone.

2 personas más completaron esta guía.

Autor

con 6 otros colaboradores

nat coll

Miembro Desde 09/27/12

642 Reputación

14 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

Cal Poly, Team 7-53, Forte Fall 2012 Miembro de Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Miembros

20 Guías creadas

2 comentarios

simple clear and precise. Small problem fixed in no time, thank you very much!

Kimmo Pekari - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 17

Ultimos 30 días: 69

Todo El Tiempo: 17,292