Before disassembling the device, make sure it is powered off.
  • Before disassembling the device, make sure it is powered off.

  • Remove the four 1.5mm screws on the back of the device.

Agregar Comentario

Using a plastic opening tool, lift the metal backing from the front of the device.
  • Using a plastic opening tool, lift the metal backing from the front of the device.

Agregar Comentario

Pull the rear panel off of the Sansa e260R.
  • Pull the rear panel off of the Sansa e260R.

Agregar Comentario

Grip the bottom of the battery with your thumb and forefinger and pull it away from the device.
  • Grip the bottom of the battery with your thumb and forefinger and pull it away from the device.

Agregar Comentario

Remove the four 1.5mm screws on the inner casing of the device.
  • Remove the four 1.5mm screws on the inner casing of the device.

  • These screws are very small and hard to extract from the casing. It may be helpful to use a magnetic screwdriver.

Agregar Comentario

Flip the device so that the front is facing you.
  • Flip the device so that the front is facing you.

  • Slide a plastic opening tool between the plastic front cover and the metal back cover of the device.

Agregar Comentario

Pull the front cover away from the rest of the device. Pull the front cover away from the rest of the device.
  • Pull the front cover away from the rest of the device.

Agregar Comentario

Near the charging port, pull the case away from the motherboard to create clearance to remove the motherboard. Use the spudger to push the motherboard in and pop the metal edge of the charging port up and inside the plastic case.
  • Near the charging port, pull the case away from the motherboard to create clearance to remove the motherboard.

  • Use the spudger to push the motherboard in and pop the metal edge of the charging port up and inside the plastic case.

Agregar Comentario

Pull the bottom of the motherboard up and then out.
  • Pull the bottom of the motherboard up and then out.

Agregar Comentario

On the back of the motherboard, there is a rectangle of rubber.
  • On the back of the motherboard, there is a rectangle of rubber.

  • Peel the rectangle off slowly.

Agregar Comentario

Under the rubber rectangle, there is a strip of black tape.
  • Under the rubber rectangle, there is a strip of black tape.

  • Peel the tape off about halfway so that it is no longer attached to the memory board.

Agregar Comentario

Carefully peel the memory board away from the rest of the motherboard
  • Carefully peel the memory board away from the rest of the motherboard

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

JenniferW

Miembro Desde 31/01/12

128 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 8-15, Maness Winter 2012 Miembro de Cal Poly, Team 8-15, Maness Winter 2012

CPSU-MANESS-W12S8G15

5 Miembros

5 Guías creadas

thanks a million for this. i accidentally erased the boot partition, bought another one on eBay with a defective audio channel and switched the memory board: eureka! i’m happy listening to my tunes again!

Admin User - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 5

Todo El Tiempo: 2,103