Introducción

How to remove & replace the phone's antenna.

Partes

No se requieren partes.

Orient the phone with the screen facing down.
  • Orient the phone with the screen facing down.

  • Using your thumb, slide the back panel away from the camera to expose the battery.

Agregar Comentario

Grip the battery on its sides, opposite the direction of the white arrow. Pry the battery up. It will pivot at the end with the white arrow. The battery will now be free.
  • Grip the battery on its sides, opposite the direction of the white arrow.

  • Pry the battery up. It will pivot at the end with the white arrow. The battery will now be free.

Agregar Comentario

Remove the 6 outer screws.
  • Remove the 6 outer screws.

    • The screws should be 3.5 mm in length.

  • Put the screws in a safe place as they are very small and easy to lose.

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Snap off back the cover by gently prying around the top and bottom edges with a flat head screwdriver.
  • Snap off back the cover by gently prying around the top and bottom edges with a flat head screwdriver.

    • It may help to slide the touchscreen upwards when removing the back panel.

  • The side buttons will become loose and are prone to fall out, so put these in a safe place.

Agregar Comentario

To free the circuit board, remove the black wire that is holding it down.
  • To free the circuit board, remove the black wire that is holding it down.

    • You can remove the wire by gently prying up the gold terminator that is attached to the green circuit board. A gentle tug is all it will take.

Agregar Comentario

The circuit board will still be held on by a blue and black ribbon that is removed by gently pulling it upwards. The circuit board will still be held on by a blue and black ribbon that is removed by gently pulling it upwards.
  • The circuit board will still be held on by a blue and black ribbon that is removed by gently pulling it upwards.

Agregar Comentario

Remove the 3.9mm screw holding the bottom black piece (antenna assembly) into place. The antenna assembly will snap off.
  • Remove the 3.9mm screw holding the bottom black piece (antenna assembly) into place.

  • The antenna assembly will snap off.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Saul Villatoro

Miembro Desde 25/04/11

255 Reputación

14 Guías creadas

Equipo

Cal Poly, Team 8-10, Regan Spring 2011 Miembro de Cal Poly, Team 8-10, Regan Spring 2011

CPSU-REGAN-S11S8G10

4 Miembros

22 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 2,744