Introducción

This guide shows you how to access the LCD display inside your phone.

Press button on back of phone below camera.
  • Press button on back of phone below camera.

  • While button is depressed, remove the back panel of the phone by sliding off (not shown in picture).

Agregar Comentario

Grasp the battery near the bottom with two fingers.
  • Grasp the battery near the bottom with two fingers.

  • Lift battery up and out gently.

Agregar Comentario

Remove the rubber screw cover in the top left corner by prying it up with an iPod opener tool.
  • Remove the rubber screw cover in the top left corner by prying it up with an iPod opener tool.

Agregar Comentario

Use a Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.
  • Use a Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.

  • The upper right screw is 4.5 mm and the others are 6.5 mm.

Agregar Comentario

Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips. There are three clips on each side and two at the bottom of the phone.
  • Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips.

  • There are three clips on each side and two at the bottom of the phone.

Agregar Comentario

Once all eight of the clips have been unhooked, lift the back panel off of the phone.
  • Once all eight of the clips have been unhooked, lift the back panel off of the phone.

  • Be careful not to remove the front panel. It is still connected to the phone chassis by a ribbon cable in the bottom right corner of the motherboard.

Agregar Comentario

Using an iPod opening tool, undo the ribbon cable clip half way up the right side.
  • Using an iPod opening tool, undo the ribbon cable clip half way up the right side.

  • Carefully remove ribbon cable.

Agregar Comentario

Remove the front faceplate by lifting it off of the phone chassis.
  • Remove the front faceplate by lifting it off of the phone chassis.

Agregar Comentario

Using the iPod opening tool, unlatch the LCD ribbon cable.
  • Using the iPod opening tool, unlatch the LCD ribbon cable.

Agregar Comentario

Using a 1 mm flat head screwdriver, carefully pry under the lower left and right corners of the LCD screen.
  • Using a 1 mm flat head screwdriver, carefully pry under the lower left and right corners of the LCD screen.

  • The LCD is held in place to the chassis with adhesive strips.

  • Do not pry excessively hard or you may damage the circuitry on the back of the LCD.

Agregar Comentario

Lift the LCD display out from phone chassis.
  • Lift the LCD display out from phone chassis.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Mark Wyse

Miembro Desde 19/04/11

70 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 15-15, Regan Spring 2011 Miembro de Cal Poly, Team 15-15, Regan Spring 2011

CPSU-REGAN-S11S15G15

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,786