Introducción

This guide will be showing step-by-step instructions on how to get to and replace the barrel of the airsoft gun.

Partes

No se requieren partes.

Using a flathead screwdriver, remove the pin holding the hand guard in place. To remove this, turn the pin clockwise and push it through at the same time.
  • Using a flathead screwdriver, remove the pin holding the hand guard in place.

    • To remove this, turn the pin clockwise and push it through at the same time.

  • Pull the hand guard off.

Agregar Comentario

Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.
  • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.

Agregar Comentario

Locate the button to fold over the folding stock and fold over the folding stock. Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.
  • Locate the button to fold over the folding stock and fold over the folding stock.

  • Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.

Agregar Comentario

Guía de regalos para el día del padre
Honremos a más que nuestros padres—celebremos a todos los mentores que nos enseñaron a reparar.
Guía de regalos para el día del padre
Honremos a aquellos que nos enseñaron a reparar.
Turn the gun over so that you are facing the bottom of the gun. Using a Phillips #1 screwdriver, remove the following screws:
  • Turn the gun over so that you are facing the bottom of the gun.

    • Using a Phillips #1 screwdriver, remove the following screws:

      • Remove the 8mm screw located directly underneath the cocking lever.

      • Remove the 8mm screw beside the one you just removed.

Agregar Comentario

Carefully tug on the tip of the gun and pull the barrel and its cover out. Carefully tug on the tip of the gun and pull the barrel and its cover out.
  • Carefully tug on the tip of the gun and pull the barrel and its cover out.

Agregar Comentario

Pull the barrel out from the cover. Remove the pieces at the end of the barrel. Remove the pieces at the end of the barrel.
  • Pull the barrel out from the cover.

  • Remove the pieces at the end of the barrel.

Agregar Comentario

Remove the remaining pieces of on the ends of the barrel. Remove the remaining pieces of on the ends of the barrel.
  • Remove the remaining pieces of on the ends of the barrel.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Laura Schulz

Miembro Desde 05/10/12

1 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 18-41, Regan Fall 2012 Miembro de Cal Poly, Team 18-41, Regan Fall 2012

CPSU-REGAN-F12S18G41

6 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 11

Todo El Tiempo: 1,083